If the tail pushrod is not the proper length, the heli will yaw either nose left or nose right with no yaw input from the stick. Maybe its leftover from the rate mode only gyro days, but when first setting up a heli, I like to pick a headspeed (typically its my middle head speed that is a rough average of my idle-up1, idle-up 2 and idle-up 3 speeds), then set the gyro to rate mode and hover at that middle (idle-up 2) headspeed. This is very confusing as it is implemented.Īs you mentioned above, the only time I need it is in initial set-up of the heli. Specifically, setting the gyro gain channel to a negative value to activate rescue is a process only necessary for transmitter system with limited channels.īased on the comments above.I request a firmware revision that allows gyro gain channel value to control the gyro function (heading hold vs rate mode) as well as the actual gain of the gyro.regardless of the state of the stabi channel assignment.
I suspect this has something to do with the FBL firmware and how its written/implemented for the GTR.further, I bet it has something to do with the work-around to accommodate transmitters that don't have enough channels to control things independently. They are two very separate and distinct functions. In fact, I see absolutely no connection between the two. What in the world does that mean?.How are the functions of Rescue and Gyro Gain related? I can absolutely see a need to control the gyro mode (either heading hold or rate mode) and rescue independently. Your comment: "The only thing not working is setting Gyro into rate/normal mode once rescue is setup (and there would be no sense in doing so anyhow)"